17
FP8K-B / FP8K-DX / FP8K-DX-XLT
Jun 2017-A
SAVE THESE INSTRUCTIONS
SAFETY INSTRUCTIONS
When using your garage equipment, basic safety precautions should always be followed, including the
following:
Ø
Read all instructions
Ø
Care must be taken as burns can occur from touching hot parts.
Ø
Do not operate equipment with a damaged cord or if the equipment has been dropped or damaged -
until it has been examined by a qualified service technician.
Ø
Do not let a cord hang over the edge of the table, bench, or counter or come in contact with hot
manifolds or moving fan blades.
Ø
If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment should be used. Cords rated for less current than the equipment may overheat.
Ø
Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug
from the outlet. Grasp plug and pull to disconnect.
Ø
Let equipment cool completely before putting away. Loop cord loosely around equipment when storing.
Ø
To reduce the risk of fire, do not operate equipment in the vicinity of open containers of flammable
liquids (gasoline).
Ø
Adequate ventilation should be provided when working on operating internal combustion engines.
Ø
Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
Ø
To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
Ø
Use only as described in this manual. Use only manufacturer
’s recommended attachments.
Ø
ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they
are not safety glasses.
SAFETY PROCEDURES
Ø
Never allow unauthorized persons to operate lift. Thoroughly train new persons/employees in the use,
operation and care of lift.
Ø
CAUTION!
Power unit operates at high pressure.
Ø
Remove passengers before raising vehicle.
Ø
Prohibit unauthorized persons from being in shop area while lift is in use.
Ø
Total lift capacity is 8,000 lbs. (4,000 lbs. per axle). Do not exceed this capacity.
Ø
Prior to lifting vehicle, walk around the lift and check for any objects that might interfere with the
operation of lift and safety latches; tools, air hoses, shop equipment.
Ø
When approaching the lift with a vehicle, make sure to center the vehicle between the columns. Slowly
drive the vehicle up with someone outside the vehicle guiding the driver.
Ø
Prior to lowering vehicle, walk around the lift and check for any objects that might interfere with the
operation of lift and safety latches; tools, air hoses, shop equipment.
Ø
Slowly drive the vehicle on and off of the lift. Have someone outside the vehicle guide the driver.
CAUTION!
LUBRICATE ALL CABLE SHEAVES, BEARINGS, AND SHAFTS WITH GREASE PRIOR TO OPERATING
THE LIFT. LUBRICATE ALL ON AN ANNUAL BASIS.
Motors and all electrical components are not sealed against the weather and moisture. Install this lift in a
protected indoor location. Failure by the owner to provide the recommended shelter could result in
unsatisfactory lift performance, property damage, or personal injury.
Содержание FP8K-B
