Tuttnauer 1730E, Руководство по эксплуатации и техническому обслуживанию

Страница: 31 / 57

29
6 INSTALLATION INSTRUCTIONS
Caution:
The sterilizer must be placed on a rigid and leveled surface. The counter must
be able to hold the load of the device and loaded material as follows:
Model
1730 2340 2540 3140 3850 3870
lb
75 106 117 172 245 278
load on
Counter
kg 34 48 53 78 111 126
Note:
Make sure while placing the autoclave, to leave space around the machine, to
give the technician access to service the machine.
6.1 Electrical
The electrical connection should comply with the device's power
requirement. It must also comply with local installation and safety rules
and regulations. The voltage supplied to the device must comply with the
label

5%.
In order to avoid any injury by electrical hazard, it is mandatory for the
customer to have installed an earth leakage relay (GFI outlet or circuit
breaker) in the electrical circuit to which the autoclave is connected. This
relay disconnects all the poles of the electrical power line in case of
accidental contact with the autoclave’s metal enclosure, by the operator
or another person, leading to a dangerous leakage current.
Note: Keep the back and the right side of the autoclave approximately 1”
(25mm) away from the wall to allow for ventilation.
Connect the power cord to the socket on the rear side of the autoclave;
plug it into the supply outlet. The autoclave must be connected to a
properly grounded outlet.
6.1.1 Setup for new units 2340, 2540, 3140, 3850 & 3870
Your new Tuttnauer Autoclave was set at the factory and requires a
minimal of setup.

Make sure the counter is level and sturdy.

Make sure all the feet are on the autoclave and none have been
lost.

Position the autoclave on the counter.

Fill the reservoir with distilled water (see sec 6.5).

The unit is ready to operate.