Turnstiles TPW-321ASP, Руководство по эксплуатации

Страница: 9 / 22

7
The turnstile should carry out the relative actions reliably when the upstream management
software is used to carry out operations for the turnstile such as rod up/down, open barrier,
counting value of read/reset counter. If not, it is necessary to check carefully the
communications lines and connectors.
For detail operation method and contents, refer to Appendix A1.
6. Operation Instruction of the Equipment
Once the mechanical and electrical installation of the turnstile has been completed, it can
be put into service.
Check before startup
6.1 The equipment can only be used after the above test to ensure a normal operation of the
equipment.
6.2 It is forbidden for the passenger to push, lean or pull the barrier rod during the card
reading or prior to the indicator changing into a green lamp. Otherwise, the normal
operation of equipment may be affected.
6.3 It is forbidden to sit or press with force on the barrier rod when the equipment is not in
use, otherwise, the turnstile may be damaged.
6.4 It is recommended that the equipment not be used directly in the exposed site, or in
humidity or corrosive environment. Otherwise, the application life of equipment may
be affected due to rain, humidity or corrosive subject (for application in outdoor,
rainproof facilities such as sun shading board should be used).
6.5 For passing, it is only needed for the passenger to push slightly the barrier rod and the
equipment will then drive the barrier rod to move automatically. It is not allowed to
push the barrier rod with strong force during the passing.
！
Precautions:
1) Please do not use the system when there is lightning, otherwise the turnstile may be
damaged.
2) It is required to connect reliably the protection grounding of the system to avoid
accident of personnel injury.