14
Appendix C Turnstile Control Board
1Communication Protocol Specifications
Could choose RS232, RS485 OR UDP interface to Communicate between
c
ontrol board & PC
1.1 Initialization & reading control board parameters
PC send communication demand [address(if you choose UDP interface, no need
a
0x02 0xFF 0x00 0x04
] to control board. Control board receive communication
demand and send feedback signal [address(if you choose UDP interface, no need
a
0x02 0xFF 0x00 0x04
] to PC, until PC send feedback signal [address(if you
choose UDP interface, no need a
0x02 0xFF 0x00 0x04
] or overtime (waiting
time is 2 seconds). The control board of turnstiles will send related parameters after
received feedback signal. Every parameter sent by main board needs the feedback
signal [address(if you choose UDP interface, no need a
0x02 0xFF 0x00 0x04
]
from PC, then send the next parameter. Or overtime (waiting time is 2 seconds).
Sending parameters as follows:
1) Equipment Model Number
2) Software Version Number
3) Equipment ID Number
4) Turnstile Working Mode
5) Working Mode of Entry & Exit
6) Door Closing Delay
7) Door Opening & Closing Speed (inapplicable to tripod turnstiles)
8) Entry Counting
9) Exit Counting
10) IR Sensors’ Sensitivity (inapplicable to tripod turnstiles)
For detailed corresponding command formats, please refer to 2. Control Board Sending
Command. Below is the flow Chart:
Содержание TPW-321ASP
Страница 1: ...OPERATING MANUAL AUTOMATIC SWING GATE TPW 321ASP...
Страница 13: ...11 Attached Figure 4...
