RSSI Alarms
: TxRSSIalrm and RxRSSIalrm refer to the levels at which warning beeps are produced
directly by the FrSky module (see page 10). The numbers here are read from the transmitter
module. If you have modified a FrSky DJT module in accordance with the instructions in the manual
Introduction to the Hardware,
these numbers may not appear. They are normally set to zero (turned
off), as shown above, to avoid conflict with the RSSI alarms set on the Telemetry page,.
mAh Alarm:
This warns when a set amount of battery capacity has been used. A current sensor
must be used to provide the necessary input. The sound or haptic buzz used for the warning can be
selected from the list provided. This value is used for the calculation of the percentage capacity used
and can be displayed on the custom telemetry display.
Num Blades
: Number of blades for the RPM sensor.
AltAlarm
is the altitude alarm. Altitude is measured by a barometric device in the
Winged Shadow
How Hi
unit. A frequently used setting is 122 metres (which will display as 400 feet if ‘Imperial’ is
selected on the previous telemetry page).
Voltage Thresh
(Threshold): Allows the alarm threshold to be chosen.
GpsAltMain
is the Global Positioning System (GPS) determination of altitude and may be turned ON
or OFF. If ON, the barometric altitude reading is replaced by GPS altitude.
Telemetry 2 Custom Display
Short presses of the DOWN key will take you to the custom telemetry display screen.
Up to six telemetry variables can be displayed on a single screen in the order you select. Highlight
the blank line and using the LEFT or RIGHT keys select from the options available. You must have
the corresponding telemetry sensors and hub installed in your model. BT (Bluetooth) . Telemetry
may be OFF or ON.
FrSky Port refers to the port used to connect the FrSky telemetry hub to the receiver. It may be
either port 1 or port 2
Each field in the custom display can be one of the various available parameters as follows:
Tmr1,2
: Both timers in the transmitter
RSSI
: Lowest of the RSSI values from the radio and receiver in D8 mode
A1, A2
: Analog ports on D receivers Alt: Barometric altitude sensor
Rpm
: Engine speed, number of blades is adjusted in the settings above
Fuel
: Fuel level, mAh consumed
.
The display is in percentage used. When the FrSky fuel
capacity sensor is used the custom telemetry screen displays 100, 75, 50, 25, and 0
percent. If a current source is selected, the display is in percentage of the value set on
Ersky9x Explained – version 1
page
39
of 45
