The
‘mode’
column selects how PPMin is used when the Trainer Switch is activated:
off
Channel unused
. No input from student stick
+= Add
student stick value to instructor stick value (sometimes used for training)
:=
Replace
instructor stick value with student stick value (normal training setup)
The
‘%’
entry applies a weighting to the PPMin value from -100 to +100. Use -100 to reverse the
input. Values closer to 0 reduce the student`s control sensitivity.
The ‘
src’
entry selects the PPMin channel for the function. In this example, the buddy box uses the
Spektrum/JR channel order of TAER, while the master uses RETA.
The ‘
sw’
entry selects the switch used to activate trainer operation, normally TRN.
Multiplier
: Adjusts PPMin values by a factor from 1.0 to 5.0. Normally left at 1.
This is used to raise the incoming signal level if it is too low for the 9XR Pro.
Cal
: Center calibration for first 4 PPMin values.
Allows you to calibrate the mid-point for channels 1 to 4. Highlighting ‘Cal’ and pressing MENU
will adjust the inputs from the slave to match the master.
NOTE: There is an option under Model Setup to enable or disable the trainer function for that model.
If you do not need a model to support trainer mode you may disable the function and use the trainer
switch for something else (see page 21).
While a trainer setup normally uses only the first four channels, all PPMin values are available to the
mixer if required.
Memory Stat (page 3/11)
This page gives the hexadecimal address for the start and end of each model in memory.
Ersky9x Explained – version 1
page
15
of 45
