Flash on Beep
Set this ON if you want the screen to flash every time the transmitter beeps.
Light Switch
The back light can be set to turn ON via any of the transmitter physical switches (RUD, ID0, ELE
etc.) or any of the virtual switches (SW1, SW2, etc.).
Light Off After
This may be set as OFF or in 5 second intervals up to 600 seconds.
Light on Stick Movement
This may be set as OFF or in 5 second intervals up to 600 seconds.
Splash Screen
This may be set to ON or OFF. The splash screen is displayed at start up with an announced
welcome message. An alternative is to have the model name announced or some music played.
The splash screen and the announcements on start-up can be customized using voice
commands as explained in a different part of this manual.
Splash Name
This may be set to ON or OFF. If ON, the name set in
Owner Name
above will be shown on the
splash screen.
Throttle Warning
If ON this will show a warning when throttle is not at idle when the transmitter is turned on. The
transmitter will not output a signal until such alerts are cleared.
Alarm warning
This will give you a “heads up” if the beeper is silent. If ON and the beeper is set to '0' (Quiet) you
will receive a warning on startup.
Ersky9x Explained – version 1
page
9
of 45
