TurfEx RS7200, Руководство владельца/оператора

Страница: 25 / 53

25
© Trynex International 2012
Maintenance
Maintenance and Service
Improper maintenance can cause serious injury.
• Lock brake, stop engine and disconnect spark plug wire. Wait
for all movement to stop before performing any adjustments,
cleaning or repairs.
• Clean grass and debris from drives, mufflers, and engine to help
prevent fires. Clean up oil or fuel spillage.
• Let engine cool before storing and do not store near flame.
• Shut off fuel while storing or transporting. Do not store fuel near
flames or drain indoors.
• Park machine on level ground. Never allow untrained personnel to
service machine.
• Use jack stands to support components when required.
• Carefully release pressure from tires and spray system.
• Remove spark plug wire before making any repairs.
• Keep hands and feet away from moving parts. If possible, do not
make adjustments with the engine running.
• Keep all parts in good working condition and all hardware
tightened.
• Replace all worn or damaged Machine Safety Labels.
• Replace worn or damaged footpads.
• Perform all scheduled maintenance as directed in the Service
Manual.
Read Safety Manual WARNING “Safety Devices” now.
Check Engine and Clutch Oil
Please refer to your Honda Engine Manual that is provided with
your RS7200 for any Engine maintainence.
IMPORTANT: Low oil level can cause serious engine or clutch
damage. Check oil level regularly. Check before operating. Keep oil
level between “full” and “add” marks. Do not operate engine if oil
level in engine or clutch are below or above the full and add marks.
Replacing Throttle Lever
• Remove Handgrip
• Loosen Lever tensioning Screw
• Remove cable
• Replace Throttle Lever in reverse order
Replacing Throttle Cable
• Remove Handgrip
• Loosen Lever tensioning Screw
• Remove cable
• Replace Throttle Lever in reverse order
Read Safety Manual WARNING, Safety Devices before
starting or operating the Triumph.
Engine speed is part of the Throttle/Clutch Safety Device. Keep the
top speed at 3450 RPM.
DO NOT over-speed engine.
Spinner Shaft coupler
Loosen Bolts
After adjusting, Conduct the Safety Device Test “Brake Systems”,
in the “Driver’s Training and Operation” section of this Manual.
Read Safety Manual WARNING “Safety Devices” before starting or
operating the RS7200.
Adjusting Pressure in Fluid-filled Tires
On a level open area free from obstructions and bystanders, lock
front Brake, shift into Neutral, and start engine.
Tires are filled with pressurized Windshield Washer Solution to
provide ballast for a lower center of gravity. Explosive separation of
rim and tires may cause serious injury.
• DO NOT remove fluid from tires.
• All replacement tires must be fluid filled.
• Wear a face shield when checking, filling, and repairing fluidfilled
tires.
• Do not attempt to check, repair or replace fluid fill tires without
the proper equipment.
• Use a clip-on chuck and extension hose. Stand to the side of the
tire when filling.
• Always maintain tire pressure at 12 PSI. Do not under or over
inflate tires.
• Rear tires have split rims. Release tire pressure prior to loosening
any nuts or bolts.
• Never weld or heat the tire rims as this could cause a tire
explosion or structural damage to the rim.
• Check tires often for cuts, wear, bubbles and missing or lose lug
nuts. Check pressure often.
• Fix or replace worn or damaged tires, rims, and hardware.
Read Safety Manual WARNING “Tire Safety” before starting, operating
or performing repairs or maintenance on the RS7200. Fluid-filled
tires are Safety Devices. Keep pressure at 12 PSI. DO NOT operate
machine without Fluid-filled tires. Replace any lost fluid.