30
85812
MAIN WIRING HARNESS
(See Figures 11, 12, and 14)
The main electrical harness provides electrical
connections for the electrical power supply connection,
chassis ground, manifold solenoid wiring connections,
and the hand-held ON/OFF switch wiring harness.
The main electrical harness starts near the front of the
WideSpin 1530 TM frame and ends at the hydraulic
manifold block.
MANIFOLD BLOCK WIRING CONNECTIONS
(See
Figures 11, 12 and 13)
The manifold solenoid wiring connections provide
electrical power to the solenoids S1 and S2.
The connector with the black and green wires goes to
solenoid S1. The connector with the black and black
wires goes to solenoid S2. The black wires from both
connectors are attached to the WideSpin 1530 TM
frame to provide ground (
-
) for the circuit.
The hand held control box switch must be in the ON
(
I
) position (for both the conveyor belt and the spinner
assembly) to test for voltage at solenoids S1 and S2.
During operation, when the solenoids are activated,
they close the valves allowing hydraulic flow to power
the hydraulic motors. No electrical power is present
at the solenoids when the hand held switch is in the
OFF (
O
) position. Hydraulic pressure is not needed to
check the solenoids or the electrical connections.
UNUSED CONNECTORS
(See Figures 11, 12 and 14)
The unplugged connectors are used for a fan switch
and fan motor on another product.
On product no.
85812, the electrical connectors are left unplugged.
Unplugged connectors are protected by a sealed blank
plug.
Electrical power is present at the connector that is
used for the fan switch. Positive (
+
) voltage will always
be present at the input side of the connection (white
wire). The hand held control box switch does not need
to be in an ON (
I
) for power to be present.
FIGURE 14
-
+
FUSE 15 AMP
TYPE AGC-15A
WIDESPIN 1530 TM ELECTRICAL SCHEMATIC
S1
S2
HAND HELD CONTROL BOX
WIDESPIN 1530 TM
MANIFOLD
BLOCK
+
+
+
+
+
+
+
+
-
-
-
1
2
3
4
5
6
UNUSED
CONNECTORS
SV85812-07
+
SERVICE LEVEL MAINTENANCE
