16
85812
Adjusting Spinner Wheel Vanes
(See Figures 6 and 7)
Changing the vane mounting angle is necessary
during the changeover between Lightspread and
Heavyspread operations.
TO AVOID SERIOUS INJURY,
Always Stop the Engine Before Making
Adjustments to the Spinner Vanes.
LIGHTSPREAD
- Readjust spinner to maximum
mounting angle (to inside of slot).
HEAVYSPREAD
- Readjust spinner to minimum
mounting angle (to outside of slot).
The mounting angle is adjusted by loosening the
inside locking screw on the vane (it is not necessary
to loosen the screw on the outside), sliding the vane to
the other end of the slot on the vane, and retightening
the screw.
NOTE:
Because the right and left spinner
wheels rotate in opposite direction, the right and left
vanes are a mirror image of each other. See Figure 6
for the location and direction of adjustment for each
individual vane.
Setting WIDESPIN 1530 Conveyor Belt Speed
Control
Turning the control knob
counterclockwise increases
the belt speed - clockwise
slows the belt speed.
Use the following speed settings for Lightspread or
Heavyspread operations. The settings are from a fully
closed (clockwise) position.
LIGHTSPREAD
- Set the belt speed control at
“1-1/4 to 1-1/2” turns open.
HEAVYSPREAD
- Set the belt speed control at
“1-1/4 to 2-1/2” turns open.
Moisture content and the type of top dressing material
are variables that may require additional adjustments
to the setting of the speed control.
Changing the conveyor belt speed control does not
affect the operating speed of the spinner assembly
spinner wheels.
VANE
(SHOWN IN
LIGHTSPREAD
POSITION)
SLOT
MOUNTING
ANGLE
FIGURE 7
INSIDE LOCKING SCREW
OP85811-08
WARNING
1
2
3
4
5
1
2
3
4
5
OPERATION
