9
SETUP AND ASSEMBLY
HOPPER DEFLECTORS AND MANUAL TUBE
INSTALLATION
(See Figure 3)
Step 5.
Insert a hopper deflector into the slots on the
top of the rear hopper panel. Secure the deflector
to the hopper using 1/4” x 5/8” hex head Whiz-Lock
screws and nuts. Tighten screws securely.
Step 6.
Insert a hopper deflector into the slots on the top
of the front hopper panel. Secure the deflector to the
hopper using 1/4” x 5/8” hex head Whiz-Lock screws
and nuts. Use the two middle screws to fasten the
manual tube to the outside of the hopper. Tighten
screws securely.
Step 3.
Install a 1/4” clip nut to each top corner of the
side panels. (Quantity 4)
Step 4.
Assemble the front and rear panels to the side
panels. The flanges on the front and rear panels
should be outside of the ends of the side panels. The
ends of the front seal should be over the front ends
of the side seals. Attach the panels with a 1/4” x 5/8”
long hex head Whiz-Lock screw at each top corner
(Quantity 4), and 1/4” x 5/8” long hex head Whiz-
Lock screws and nuts down each corner (Quantity
16). Insert screws from the inside and place nuts on
the outside.
DO NOT TIGHTEN SCREWS AT THIS
TIME.
HOPPER DEFLECTORS
MANUAL
TUBE
1/4" x 5/8" HEX
HEAD SCREWS
1/4"
NUTS
1/4" NUTS
FIGURE 3
HOPPER ASSEMBLY
AS85804-02
FRONT OF T
OP
DRESSER
