turck TBEN-S2-2COM-4DXP, Инструкция по эксплуатации

Страница: 76 / 171

Commissioning
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com 70
 Object Instance 2, gateway Instance
Attr. No. Attribute name
G
et/
S
et
Type Description
Dec. Hex.
109 0x6D Status word
(Status register 2) G STRUCT The Status Word contains general module
status information:
Module
–
Bit 15: reserved
–
Bit 14: Force Mode active, "Force Mode
Active Error“ (FCE)
The Force Mode is activated, no access to
the module possible because there is
already a connection to the DTM active .
–
Bit 13…bit 10: reserved
Voltage errors
–
Bit 09: V1 too low
(< 18 V DC).
–
Bit 08: reserved
–
Bit 07: V2 too low
(< 14 VDC).
–
Bit 06…bit 1: reserved
Warnings
–
Bit 00: Module diagnostics pending
(DIAG). At least 1 channel sends diagnos-
tics.
115 0x73 ON IO
CONNECTION
TIMEOUT
G/S ENUM USINT Reaction to the I/O connection exceeding
the time limit.
SWITCH IO FAULTED (0):
The channels are switched to substitute
value.
SWITCH IO OFF (1):
The outputs are switched to 0.
SWITCH IO HOLD (2):
No further changes to the I/O-data. The out-
puts are held.
138 0x8A GW Status
Word
Get/
set DWORD Activates or deactivates the mapping of the
status word into the device's input data.
139 0x8B GW Control word Get/
Set
DWORD Activates or deactivates the mapping of the
control word into the device's output data.
140 0x8C Disable Protocols Get/
set
UINT Deactivation of the used Ethernet protocol.
Bit assignment of protocols:
Bit 0 = EtherNet/IP™ (can not be
deactivated via the EtherNet/IP™ interface)
Bit 1 = Modbus TCP
Bit 2 = PROFINET
Bit 11…bit 14 = reserved
Bit 15 = Web server