turck TBEN-S2-2COM-4DXP, Инструкция по эксплуатации

Страница: 63 / 171

57
2018/03
Configuration Assembly (Instance 106)
The modules support Configuration Assembly. It enables an EDS-based configuration/parameter-
ization of the devices in the PLC software (if supported by the PLC).
The Configuration Assembly contains:
10 bytes device configuration data (EtherNet/IP™-specific)
+ 218 bytes (parameter data)
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Dec. Hex.
Device configuration data, see
Device configuration data, page 59
0…9 0x00…
0x09
-
Eth 2
Port Setup
Eth 1
Port Setup
QuickCon-
nect
Parameter data
COM0
Setting Parameters, page 117
10 0x0A - Operation mode
11 0x0B
-
Swap A/B
line
12 0x0C - Data rate
13 0x0D - Character format
14 0x0E - Stop bits
15 0x0F - EOF detection
16 0x10
-
Termination
active
17 0x11
-
Biasing
active
18 0x12 - Power supply VAUX1
19 0x13 -
20 0x14
Character timeout
21 0x15
22 0x16
Response timeout
23 0x17
24 0x18 1st end delimiter
25 0x19 2nd end delimiter
26 0x20
MB-Server cycle time (*1ms)
27 0x1B
COM 0 – SCB 0.0
Setting Parameters – COM0/COM1, page 117
28 0x1C Server address
29 0x1D - Number reg./server write access
30 0x1E - Number reg./ server read access
31 0x1F Read access
32 0x20 Write access
33 0x21 -
34 0x22
Start address for read access
35 0x23
36 0x24
Start address for write access
37 0x25
38 to 47 0x26 to
0x2F COM 0 – SCB 0.1
Assignment (similar to byte 29 to 37)
…
98 to 107 0x62 to
0x6B
COM 0 – SCB 0.7
Assignment (similar to byte 29 to 37)