Turbosol TB30, Руководство по эксплуатации и обслуживанию

Страница: 68 / 87

6
MAINTENANCE
68/87
561405 - IS19/07 - EN
1
2
3
If after a few consecutive checks the oil level is significantly reduced, it is possible that the system leaks. If
the leak comes from a loose fitting, tighten the fitting; if the leak comes from a pipe, have it replaced with a
new and original pipe, by an authorised maintenance technician. If you cannot find the source of the leak,
contact the Dealer or the TURBOSOL PRODUZIONE S.R.L. technical assistance to resolve the fault.
6.1.3
Engine oil level check
When When beginning work
Machine state With machine off and cold
Tools Visual inspection None
ALWAYS REFER TO THE ENGINE’S USE AND MAINTENANCE MANUAL.
Only use the type of oil reported in § 2.1. Do not mix different oils as they can damage the engine.
If after a few consecutive checks the oil level is significantly reduced, it is possible that the engine is not
working properly. Contact the Dealer, the TURBOSOL PRODUZIONE S.R.L. technical assistance or an
authorised workshop directly.
6.1.4
Fittings and material conveying pipe check
When When beginning work
Pipe state Clean, disconnected from the machine
Tools Visual inspection None
The conveying pipe could be composed of a iron hose or rubber hose, to the ends of which the fittings are crimped
(permanently). The fitting contains a indipendent removable sealing gasket.
Visually check the good condition of the conveying pipe, fittings and gaskets. The outer surface of the rubber hose must not be
cut or cracked; also, the rubber near the fittings must be intact, both internally and externally. The fittings must not be
deformed. The gaskets must not be cut or deformed.
If the piping is damaged or you are not sure of its good condition, replace it with a new and original one.
If the gaskets are damaged or you are not sure of their good condition, replace them with new and original
ones.