Tume Nova 3000 Star, Руководство пользователя

Страница: 19 / 40

19
Adjustment example when sowing grain
Case 1. To sow oats 200 kg/ha.
•
The correct position of the bottom flaps is stated at the top right of the table, see "grain".
Correct adjustment is position "2"
•
Selected descriptor "oats"
•
Check the transmission of the machine, which must be "1"
•
Starting from the edge of the table in section 200 kg / ha
•
Proceed along the horizontal line to the point where this line intersects the describer "oats"
•
From the intersection point proceed directly down to the scale, where can be seen that the
adjustment must be "5.9"
That is, the hand wheel must be open 5 full turns and 0.9 turns additional. Handwheel lock is locked
to the notch marked with 9.
Adjustment example of sowing small seeds
Case 2. To sow rapeseed 12 kg/ha.
•
The correct position of the bottom flaps is stated at the top right of the table as "1".
•
Examine the small sowing table.
•
Search for a starting point in the small sowing table left side 12 kg / ha.
•
Proceed along the horizontal line in question of 12 kg / ha to the right. where this line
intersects the describer "rapeseed".
•
Go directly from the intersection to the lower scale, and we can see that the correct setting
is "1.0".
•
It is noted that in the upper left corner of small sowing table is a marking "transmission II".
That is, in the transmission a small seed setting must be used meaning the cassette must
be turned so that the cassette is as indicated in position "II".
Adjustment example, fertilizer side
Case 3. To sow NPK-fertilizer mix 500 kg/ha.
•
It is noted in the sowing table upper right corner, that the correct adjustment of bottom flaps
with correct granular fertilizer is "2", in the fertilizer side in the factory gear wheel Z 17 has
been installed
•
Starting from the edge of the big sowing table in part 500 kg / ha
•
Proceed along the 500 kg/ha -line horizontally to the right into the intersection of this line
and describer "granular fertilizer Z 17", if the chain wheel Z 17 in question (a black line in
the table).
•
From the intersection proceed directly down, where at the bottom scale it can be seen that
the main scale figure placed on the wheel lock lever must be "7.2". After the adjustments
the calibrations should be done in order to ensure a correct sowing amount.
NOTE! When attempting to get to an exceptionally large fertilizer level ( over 700 kg/ha ), the double-
chain wheel in the left end of the machine must be turned so that Z 22 is in use. Then a
maximum of appr. 900 kg/ha fertilizer can be sown . Then in the sowing table the red line
will be followed!