TSUNESS TSOL-A3.0K-H, Руководство пользователя

Страница: 47 / 54

43
• The system will back to normal if the grid is back.
• Or seek for help from us.
DCI OCP Fault
DCI over current protection Fault.
• Or seek for help from us.
• Wait for a while to check if back to normal.
DCV OVP Fault
DCV EPS over voltage protection Fault.
• Or seek for help from us.
• Wait for a while to check if back to normal.
SW OCP Fault
Over current fault detected by software.
• Wait for a while to check if back to normal.
• Turn off the battery and grid , reconnect them.
• Or seek for help from us.
RC OCP Fault
DCI over current protection Fault.
• Please check if the insulation of electric wires are damaged.
• Wait for a while to check if back to normal.
• Or seek for help from us.
Isolation Fault
Isolation Fault
• Please check if the insulation of electric wires are damaged.
• Wait for a while to check if back to normal.
• Or seek for help from us.
Temp Over Fault
Temperature over the limitation
• Check if the environment temperature is over limitation.
• Or seek help from us.
Bat ConDir Fault
Battery Reverse Connection Fault
• Check if the positive pole and negative pole of battery are
connected in a contrary way
• Or seek help from us.
Sample Fault
The detection circuit Fault
• Disconnect battery, reconnect it.
• Or seek help from us.
EPS OCP Fault
Over Current in EPS Mode.
• Make sure the load power is within the EPS power range.
• Check if any nonlinear load is connect on the EPS. Remove this
load to check if can recover.
• Or seek help from us, if can not go back to normal state.
Over Load Fault
Over Load in EPS Mode.
• Turn off high power device.
• Or seek help from us, if can not go back to normal state.
Bat Low Fault
Battery voltage is too low or battery does not exist.
• Disconnect battery, reconnect it.
• Or seek help from us, if can not go back to normal state.
Hybrid Relay fault
Hybrid Relay Fault.
•
Disconnect grid and battery, reconnect them.
•
Or seek help from us, if can not go back to normal state.