TSE DP20-4H, Руководство пользователя

Страница: 18 / 242

Figure 5: Anchoring Diagram
5.
PROPER GROUNDING OF THE MACHINE IS VERY IMPORTANT! The machine is equipped
with two grounding bars. (See figure 5.) To protect against electrical hazards due to induction or
electrical contact, the system must be connected to a proper ground rod or the electrical system
neutral. Follow proper grounding procedures as required by IEEE and/or the applicable standards
in your area. Use of a ground mat and a running ground on the conductor are highly
recommended.
6. Put a hazard barrier around the perimeter of the unit to keep unauthorized personnel away from
the equipment.
7. Perform daily inspection and preventive maintenance as required.
PRE START CHECKLIST
1. Ensure that the Direction Control (4) is in the NEUTRAL position.
2. Ensure that the Brake Control (3) is in the APPLY position.
ENGINE START-UP
The engine manufacturer’s manual, included in the Section V, contains detailed technical information
regarding the engine including start up procedure. Make sure you read and understand the operating
instructions contained therein. .
CAUTION: DO NOT ALTER THE RPM GOVERNER SETTING OF THE ENGINE. THE
HYDRAULIC PUMP IS LIMITED TO A SPECIFIC MAXIMUM RPM AND CAN BE DAMAGED IF
DRIVEN FASTER THAN THE GOVERNED ENGINE SPEED.
STOPPING THE ENGINE
1. Move the Direction Control (4) to the NEUTRAL position.
2. Move the Brake Control (3) to the APPLY position.
3. Decrease the engine speed to idle.
4. Allow the engine to idle for a few minutes to cool down.
5. Shut down the engine.