Tryton TJS40, Руководство по эксплуатации

Страница: 12 / 72

12
factors.
n
Cleaning
To provide safe and efficient operation, the grinder casing and ventilation
openings should be free from dust deposits and other pollutants. We
recommend that you clean the grinder directly after each use.
Wipe the grinder with a clean, slightly wet cloth with a small amount of
soap. Do not use any cleaning agents or solvents; they can damage parts
made of plastics. Protect the grinder's inner parts against water.
After using the tool in dusty atmosphere it is recommended to clean the
ventilation openings with compressed air to avoid damage to the
bearings and remove dust blocking the air used for cooling the motor.
Clean the charger only with a dry cloth
.
TRANSPORT:
PICTOGRAMS:
Explanation of the icons located on the nominal plate and the
Transport and store the angle grinder in a package that protects it
information tags :
against moisture, dust and small objects, in particular secure ventilation
openings. Small objects after getting into the casing can result in
damage to the motor.
PROTECTION OF THE ENVIRONMENT:
NOTE: The symbol nearby denotes that old equipment must
never be thrown away together with other waste (with the
penalty of a fine).
Hazardous components of electronic
equipment may adversely affect the natural environment and
human health.
Each household may contribute to the recovery and reuse (recycling) of
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
machinery and appliances. Moreover, general purpose collecting points
for such equipment are available.
If the battery is removed for transport or storage, make sure the contacts
will not short circuit. Remove metal items such as screws, nails, clasps,
loose bits, wires, or metal filings from the case or transport container or
otherwise prevent them from touching the battery.
MANUFACTURER:
PROFIX Co.Ltd.,
34 Marywilska Street,
03-228 Warsaw, POLAND.
This appliance is in conformity with national and European standards as
well as with general safety guidelines.
NOTE: In case of technical issues, contact an authorised technical service.
Any repairs are allowed to be carried out exclusively by qualified staff with
use of original spare parts.
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device
purchased.
This
instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.
« » Never dispose of batteries in water.
«Read this instruction before switching on the
power supply and starting the work.»
« » Never dispose of batteries in fire.
«
»
Protect the battery against heat, e. g., against
continuous intense sunlight.
« » For indoor use only .
TROUBLESHOOTING GUIDE:
PROBLEM POSSIBLE CAUSE REMEDY
Irregularities of the motor
operation.
Worn carbon brushes of the motor. Have the brushes replaced at a service workshop.
The angle grinder does not
work.
No power voltage, damaged
motor or the power trigger.
Check the battery status, recharge or replace with a new one when necessary.
When the problem persists hand over the tool for repair at a service workshop.
Please refer to the warranty sheet for addresses of authorized workshops.
Battery low. Recharge the battery.