TruSteel AV15, Руководство по установке

Страница: 32 / 43

AV15 INSTALLATION MANUAL | TruSteel AutoVap15 Installation Instructions | v. 1.3
32 / 43
11.Connect Water Lines (Red and Blue Hose) using instructions on tables
below. Also use the diagram above for reference.
Use this table to understand the connections
Hot Water Heater Hose Connections [Red Hose]
From Connect To
Hot Water Heater Out from Ball Valve
on Wall Evaporator Hot In (Lower Port on
Evaporator - flood fills)
Evaporator Hot Out Pre Heater Hot In (Flood Fill)
Pre Heater Hot Out Residue Vessel Hot In
Residue Vessel Hot Out Hot Water Return Ball Valve
Cold Water Line Connections (Chiller) [Blue Hose]
From Connect To
Chiller Out from Ball Valve on Wall Condenser Cold In (Lower Port on
Evaporator - flood fills)
Condenser Cold Out Vessel Cold In (Flood Fill)
Vessel Cold Out Cold Water Return Ball Valve Back to
Chiller
CHILLER FILL & STARTUP
SYSTEM REQUIREMENTS
Use this chart to determine your recommended propylene:water ratio. If you have any doubts,
please call MTA-USA.
The total volume of your water/glycol mixture is around 80 gallons total.
Propylene Glycol Relative to Freeze Point
Propylene Glycol
Solution (%) 0% 10% 20% 30% 40% 50% 60%
Temperature (F) °
Freezing Point
32 ° 26 ° 18 ° 7° (-8) ° (-29)° (-55)°
FILL CHILLER
1. Premix your desired ratio of propylene glycol and water in a clean, 30 gal. reservoir.
2. Make sure all valves throughout the chilling lines are open before filling