Trumpf BEO D50, Руководство оператора

Страница: 36 / 38

Any work on the electrical equipment of a laser product must be
carried out by a trained electrician only.
Instructed personnel may work on the electrical equipment if
■ the rules for electrical safety are observed.
■ the work is carried out under the supervision and guidance
of a trained electrician.
6.8 Instructing the personnel
As the operating company, make sure that all persons operating
the laser product have the knowledge and qualifications to do
so. In particular, the personnel needs the required awareness of
possible dangers that might be caused by the laser product.
Before starting the work, the personnel entrusted with work on
the laser product must have read the operator’s manual and the
chapter "Safety" in particular. This applies especially to persons
working only occasionally on the laser product, e.g. during main-
tenance.
If required, TRUMPF offers trainings for operators and personnel
responsible for maintenance. Please contact the TRUMPF serv-
ice department.
Inform any person in the dangerous areas by means of direc-
tives. Attach the directives clearly visible and protected in the
dangerous areas.
Directives are short informative texts, mostly not longer than a
page, which present all essential information to:
■ avoid dangers as far as possible.
■ act correctly if accidents occur in spite of safety measures.
Please observe the labels attached to the laser product. Ensure
that the labels are in a legible state. Any labels that are dam-
aged or not longer legible must be replaced.
For further information on the labels: see section "Labels".
6.9 Wearing personal safety equipment
If your risk assessment for the laser product shows that techni-
cal measures are not sufficient, persons can be protected in
addition by wearing personal safety equipment.
1 ‐ 24
Measures of the user 2020-01 22-50-17-CRen
Obligations of the owner
Read operator's manual
Training with TRUMPF
Directives
Labels