truflo TSMP Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 26 / 67

26 Revision 8 – November 2011
(0.05 -0.10 mm) lower than pump shaft, since
thermal expansion will cause the motor shaft on
foot mounted motors to "grow" up to the pump
shaft centerline.
NOTE B: For other drivers (turbines, engines, etc.),
follow driver manufacturers’ recommendations.
BASEPLATE GROUTING PROCEDURE
GENERAL PROCEDURE
Use of non-shrink epoxy grout is best.
NOTE: Grout manufacturer’s instructions should be
consulted and followed.
The following are general procedures for grouting
baseplates. Additional information may be found in API
Standard 610, 8th Edition, Appendix L, API RP 686,
Chapter 5, and other industry standards.
Baseplate Installation Procedure should be followed prior
to grouting baseplate.
1-Build form around foundation to level of bottom of
baseplate (Fig. 8).
2-Pour grout through grout hole in baseplate, up to level of
dam. Remove air bubbles from grout puddling or by
pumping the grout into place (Fig. 11).
3-Strike along top of dam with trowel to give a neat
appearance.
4-Allow grout to set.
5-Fill remainder of baseplate with grout, removing air as in
Step 2 above (Fig. 12).
6-Allow grout to set at least 48 hours. Leveling screws
should be removed when grout has hardened.
7-Tighten foundation bolts.
Maximum Allowable Parallel and
Angular Misalignment
Size
Maximum Allowable Misalignment
Parallel Angular
All
0.05 mm (.002 in.)
0.03 degrees [0.125
mm/cm (.0005 in.
/in.) of coupling face
diameter]
NOTE For electric motors, motor shaft initial (cold)