truflo TSMP Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 67

18 Revision 8 – November 2011
BASEPLATE INSTALLATION PROCEDURE
Industry standard procedures, such as API RP 686/ PIP
REIE 686, and/or the following procedure should be
followed prior to grouting the baseplate. The procedure
assumes the installer has a basic knowledge of baseplate
and foundation design and installation methods.
BASEPLATE PREPARATION
1-Inspect all surfaces of baseplate that will contact grout for
contamination (e.g. -rust, oil, grime, etc.).
1-
Thoroughly clean all surfaces of the baseplate that will
contact grout with a cleaner that will not leave any residue.

Remove water and/or debris from foundation bolt
holes/sleeves. If the sleeve type bolts are being
used, fill the sleeves with nonbinding moldable
material and seal to prevent grout from entering.

Coat exposed portion of anchor bolts with a
non-bonding compound (such as paste wax) to
prevent grout from adhering to anchor bolts.
2-Inspect all machined surfaces for burrs, rust, paint or
any other type of contamination. If necessary, use a
honing stone to remove burrs.

Chip top of foundation a minimum of 25 mm) to
remove porous or low strength concrete. If using a
pneumatic hammer, assure that it is not contaminating
the surface with oil, moisture, etc

If recommended by grout manufacturer,
coat foundation surface with a
compatible primer.
3-Coat portions of leveling screws that will contact grout
with a non-bonding (anti-seize) compound (such as paste
wax) to facilitate their removal after grouting.
4-Thread nuts on foundation bolts and hand tighten.
FOUNDATION PREPARATION
SETTING AND LEVELING BASEPLATE

Lower base onto foundation bolts. Base will rest
on top of foundation on jackscrews provided on
base (Figs. 9 & 10).

Adjust leveling jack screws, located adjacent to
the foundation bolt holes, until the baseplate rests
1-2 in. (25 -50 mm) above foundation to allow for
adequate grouting. This will provide even support
for the base once it is grouted.

Level base to within .002 in./ft. (0.20 mm/m) of
length or width of the base, respectively, by
adjusting leveling screws. Maximum total
variation from one end or side of the base to the
other is .015 in. (0.38 mm).
�
CAUTION
Do not use heavy tools such as jackhammers, as they
could damage the structural integrity of the
foundation.