110618-28
TN 20B INSERT
13
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
Crate Removal
1. Carefully remove wood top and supports.
2. Remove plastic cover.
• Remove the retaining clip on the front of the baffle before lighting for the first time
Your Insert is designed to be installed into an approved masonry or factory built zero-clearance wood
fireplace.
The masonry fireplace must be built according to the requirements of the
Standard of Chimneys,
Fireplaces, Vents and Solid Fuel Burning appliances, N.F.P.A. 211 (Latest Edition)
or applicable
National, Provincial, State or local codes. In Canada, the installation shall conform to
CAN/CSA-B365,
Installation Code for Solid-Fuel-Burning Appliances and Equipment
.
The factory built zero-clearance fireplace and its chimney must be listed per UL 127 or ULC S610
standards.
Warning: Under no circumstances is this heater to be installed in a makeshift or "temporary" manner. It
may be fired only after the following conditions have been met.
• DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
• DO NOT INSTALL IN A SLEEPING ROOM.
• THIS ROOM HEATER MUST BE CONNECTED TO A CODE APPROVED MASONRY CHIMNEY WITH A
LISTED FLUE LINER.
• DO NOT ATTEMPT TO CONNECT THIS HEATER TO ANY AIR DISTRIBUTION DUCT.
• Outside combustion air or fresh air into the room may be required in your area, consult local building
codes (see Combustion Air section).
NATIONAL
FIREPLACE
INSTITUTE
CERTIFIED
www.nficertified.org
We recommend that our products be
installed and serviced by professionals
who are certified in the U.S. by the;
NFI(National Fireplace Institute) or
CSIA (Chimney Safety Insitute of America
or in Canada by; WETT (Wood Energy Technical Training) or
APC (Association des Professionnels du Chauffage
Wood Energy
Technical Training
www.wettinc.ca
Fireplace Installation
