Fuel supply line
Fuel spray line
Air pressure line
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Install the switch and the throttle servo
Epoxy the fuel tank in the fuselage.
Notice the position of the fuel tank in the fuselage.
Install the throttle servo to appropriate position in the
fuselage.
Assembly of the fuel tank.
Assemble the switch servo to the fuselage.
Add a rubber ring to the
clevis for insuring safety
Assembly of the switch servo.
Linkage Stopper
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
1
1
1
1
10
55
54
53
50
52
51
A
A’
B
B’
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
Rudder
Vertical
fin
Cut away the rubber tube when
the epoxy glue dried.
1mm
Make sure they are in
the right position while
installing.
5mm
4
Steel wire (0.5x3000mm)
2
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x80mm)
2
Copper joiner
2
Plastical tube(3x50mm)
4
4
Clevis
Copper joiner
4
4
Screw (2x10mm)
Nut (2mm )
4
Washer(2x5mm)
2
Steel wire (0.5x3000mm)
Steel wire (0.5x3000mm)
8
TP Screw (2.3x12mm)
Ply (15x15x3mm)
8
Assembly of the stabilizer.
keep some space about 1mm width between
the vertical fin and rudder.
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Epoxy the tail retract to the frame steadily in
the fuselage as below.
The sketch map for the steel wire of tail retract.
7
38
33
35
34
37
Accessory list for the coming installation steps.
