6mm
260mm
15mm
4mm
3mm
Washer (3x6mm)
Blind Nut (3mm)
Screw (3x15mm)
Washer (3x6mm)
2
2
Screw (3x15mm)
2
Blind Nut (3mm)
260mm
8mm
2
Wooden Block (9mm)
ply(3mm)
2
162mm
305mm
419mm
Epoxy the wooden block to the breaches.
According to the location wooden block drill holes
in the fuselage.
Trim breaches to relevant position in the fuselage for
assembling the cockpit.
Epoxy plies to relevant position below the breaches
in the fuselage.
Assemble the cockpit to the fuselage and drill holes through the
ply and the wooden block in the fuselage and the cockpit,then
set blind nuts to the holes in the wooden block.
Epoxy the exhaust to the cowling.
62
63
61
65
66
64
12
1
Stab joiner (12x250mm)
9
Pin hinge(4.5x67mm)
8
2
2
2
2
2
2
Clevis
Rod (2x300mm)
Retainer
TP Screw (2.3x12mm)
Screw (3x35mm)
Washer(3x15mm)
2
Washer(3x15mm)
Lock Nut (3mm )
4
Wood dowel (4x30mm)
1
Rib template (2mm ply)
Stab joiner (30x680mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Make sure hinges are
mounted in the same line.
6
Pin hinge(4.5x67mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Install the servo as the illustration below.
5mm
4
2
Wooden Block
(17x17x8mm)
Servo tray(66x54x2mm)
Wooden Block
(17x17x8mm)
Servo tray(66x54x2mm)
2
Screw (6x50mm)
Blind Nut
Screw (6x50mm)
Fix the wings to the fuselage.
Reinforce the connection between the fuselage and
the wings by the screws as illustration.
Drill holes in the elevator and epoxy the pin
hinges to them.
Drill holes to relevant position in the stabilizers and
epoxy the elevators to them.
5
26
24
25
23
22
Accessory list for the coming installation steps.
