Clevis
Retainer
Rod (2x300mm)
Screw (2x10mm)
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x35mm)
Screw (2x10mm)
Wood dowel (4x30mm)
Rib template (2mm ply)
Drill two holes at the stabilizer root base via rib template
and epexy the wood dowel in them.
4mm
1
Rib template (2mm ply)
Rib template (2mm ply)
TP Screw (2.3x12mm)
1.5mm
3mm
8
TP Screw (2.3x12mm)
4mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
33mm
90mm
108mm
3
Pin hinge(4.5x67mm)
Make sure hinges are
mounted in the same line.
5mm
4
Wood dowel (4x30mm)
1
Stab joiner (12x250mm)
Drill holes to appropriate position in the rudder and
epoxy the pin hinges in them
Install the nylon control horn and connect the linkage.
Secure the servo of elevator and connect the linkage.
Drill two holes in the stab root base on the rib template.
Epoxy the stabilizers to the fuselage.
6
32
31
30
27
29
28
Rudder servo
Throttle servo
Switch servo
Cut off the surplus part from the cowling,exhausts and
canopy carefully.
15
Ply(15x15x3mm)
15
TP Screw (2.3x8mm)
1
Canopy
2
Pvc part
2
Canopy
6mm
2
Wood dowel (6x30mm)
Wooden Block(17x17x8mm)
2
260mm
15mm
4mm
Washer (3x6mm)
2
2
Screw (3x15mm)
2
Blind Nut (3mm)
4
Ply (17x17x8mm)
2
Plastic tube(5x50mm)
2
Wood dowel (6x30mm)
ply(3mm)
2
1
Location wooden Block (2mm)
2
Wooden Block (9mm)
1
Drop tank
1
15mm
Location wooden Block (2mm)
Location wooden Block (2mm)
Mounting the receiver and battery to appropriate
position in the fuselage.
According to the location wooden block and mark in the
cockpit through the holes in the location wooden block.
Epoxy wooden block to the relevant position behind the
marked position and drill holes through the marked point
and epoxy the wooden dowel in them.
Open breaches to appropriate position in the cockpit
as illustration.
60
56
59
58
11
Accessory list for the coming installation steps.
57
