The sketch map after the rudder shaft assemble finished.
2
Steel wire (0.5x3000mm)
2
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x80mm)
2
Copper joiner
Washer(3x15mm)
Screw (3x80mm)
Lock Nut (3mm )
Clevis
Aluminum tube
Steel wire
Drill a small hole to appropriate possition in the
fuselage for installing the plastical tube.
3mm
68mm
45mm
70mm
2
Plastical tube(3x50mm)
4
4
Clevis
Copper joiner
4
4
Screw (2x10mm)
Nut (2mm )
4
Washer(2x5mm)
Install the servo.
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Aluminum tube
The sketch map of the linkage for the rudder
and the tail wheel.
The sketch map of the steel wire for the rudder.
Assemble the servo of rudder in the fuselage.
8
44
43
42
41
40
39
In case of 2-cycle & 4-cycle engine.
250 mm
1
Linkage Stopper
4
12
Washer(5mm)
Spring Washer(5mm)
2
4
Screw(5mm)
Plastic tube (2x650mm)
Washer
4
4
Blind Nut (5mm)
Fuel tank (550cc)
1
4
Blind Nut (4mm)
5.2mm
Blind Nut
Drill four holes at the diameters as shown for engine
mount.
The front view of the engine install completion
Washer
Screw
Washer
Assemble the engine.
TP Screw (2.3x12mm)
1.5mm
8
TP Screw (2.3x12mm)
Ply (15x15x3mm)
8
Trim the surplus parts off the tail wheel cover carefully
and make sure the tail retract can get into the tail
fuselage when the gear up.
The side view when the engine install completion,
customers can adjust the engine to a appropriate
position by move the engine mount.
9
49
48
47
45
Accessory list for the coming installation steps.
46
