Troxler EGauge 4590, Руководство по эксплуатации и инструкции

Страница: 131 / 186

Model 4590 A-3
2
2
.
. Report lost or missing radioactive sources to your state or
federal radiation control agency in accordance with
applicable regulatory requirements.
3
3
.
. Contact the Troxler Radiation Safety Department for further
advice.
Gauge Readings Appear Erratic
1 1 . . Ensure that the source rod is properly positioned in the
desired measurement position.
2
2
.
. Ensure that the gauge is not wet.
3 3 . . Check count time – a four-minute count gives the highest
precision.
4
4
.
. Perform a statistical stability (stat) test.
 If test passes, proceed with job.

If test fails, repeat two more times. If test fails two out of
three times, contact the nearest Troxler Service Center.
Gauge Turns off after it is Turned On
1 1 . . The gauge automatically turns off after five hours if no keys
are pressed. Try to turn the gauge on again.
2
2
.
. The gauge may be wet. Do not turn the gauge on until the
gauge is completely dry, as component damage may
result.
3
3
.
. If the battery is below 5.5 volts, recharge or replace the
batteries.
Short Battery Life after Recharging
1
1
.
. Check that you are using the correct charger.
2
2
.
. Ensure the charging icon ( ) displays on the top-right of the
display.
3 3 . . NiMH batteries may be charged up to 500 full charge-
discharge cycles. The batteries may be reaching end of life
cycle and may need to be replaced.