Trotec TTK 900 MP, Оригинальное руководство пользователя

Страница: 12 / 23

12 EN dehumidifier TTK 900 MP
Automatic defrost
At low ambient temperatures, ice may form at the evaporator
during dehumidification. The device will then carry out an
automatic defrost. Dehumidification is briefly interrupted during
defrosting. The fan keeps running.
The duration of the defrost process can vary. Do not switch off
the device during automatic defrost. Do not remove the mains
plug from the mains socket.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• If necessary, remove the condensation drain hose and any
residual fluid from it.
• Clean the device according to the Maintenance chapter.
• Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation Article number
Room hygrostat HG 110 6.100.002.044
Condensate pump TTK 900 MP incl.
installation kit 6.100.003.030
Air filter TTK 900 MP 7.160.000.013
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damage.
• Check the on-site fusing.
• If you operate the device with a hygrostat (optional), check
the set value. In order for the construction dryer to operate,
the humidity level at the installation site needs to be higher
than the set value. Set the hygrostat to a lower value.
The device is running, but there is no formation of
condensate:
• Check whether the condensation drain hose is positioned
correctly.
• When using the condensate pump: Check the
condensation tank and hoses for dirt.
• Ensure that the relative room humidity complies with the
technical data. If necessary, switch to another fan stage
(according to chapter Operation).
• If you operate the device with a hygrostat (optional), check
the set value. In order for the construction dryer to operate,
the humidity level at the installation site needs to be higher
than the set value. Set the hygrostat to a lower value.
• Check the air filter for dirt. If necessary, clean or replace
the air filter.
• From the outside, check the condenser for dirt (see
chapter Maintenance). If the condenser is dirty, have it
cleaned by a specialist company or by Trotec.
The device is loud or vibrates:
• Check whether the device is set up in a stable and upright
position.
Condensate is leaking:
• Check the device for leaks.
The compressor does not start:
• Check the room temperature. Observe the device's
permissible operating range according to the technical
data.
• Check whether the overheating protection of the
compressor has tripped. Disconnect the device from the
mains and let it cool down for approx. 10 minutes before
reconnecting it.
• The device might carry out an automatic defrost. During
automatic defrost, the device does not dehumidify.
The device gets very warm, is loud or is losing
performance:
• Check the air inlets and air filters for dirt. Remove external
dirt.
• From the outside, check the device for dirt (see chapter
Maintenance). If the inside of the device is dirty, have it
cleaned by a specialist company for cooling and air-
conditioning or by Trotec.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to a specialist company for cooling and air-conditioning
or to Trotec for repair.