Trotec TDP 370 E, Оригинальное руководство пользователя, Страница: 7 / 17

EN 7 deep well pump TDP 370 E / TDP 750 E
Start-up
Mounting the spacer foot
The spacer foot ( 3 ) must be attached to the device prior to initial
start-up. To do so, please proceed as follows:
1. Insert the spacer foot ( 3 ) into the bottom side of the device.
2. Screw the spacer foot ( 3 ) to the bottom side of the device
by using the supplied screws ( 7 ).
3
7
Connecting the pipe or hose line
The device may be operated using either a hose line or a pipe.
Ex factory, the device is delivered with a
1 ¼" internal thread.
Please observe the following information regarding water
discharge:
• The device cannot be moved flexibly when using a solid
pipe.
• Please note that the conveying capacity declines with an
increasing height of the pressure line.
Note
If you want to connect a flexible hose as pressure line,
do not use a suction hose or a non-pressure-resistant
hose. Use pressure-resistant hoses only.
Connecting the pressure line
Warning
Make sure that all parts of the pressure line are
installed professionally. In case of an improper
assembly or when using unsuitable parts, there is a
risk of injury due to the pressurized pumping medium.
1. Remove the protective cap ( 8 ) from the pressure
connection ( 1 ).
8
1
Note
Keep the protective cap ( 8 ) of the pressure connection
so you can use it when storing the pump to protect the
inside of the pump against dust and dirt.
2. Connect the pressure line to the pressure connection ( 1 )
using a suitable adapter ( 1 ¼" ). To do so, apply thread seal
tape (e.g. Teflon tape) to the threaded connector of the
pressure line to ensure a leak-proof connection.