15
EN
Operating manual – dehumidifier / climate manager DH 30 VPR+ / DH 60 VPR+
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
1. Hold onto the mains plug while pulling the power cable out
of the mains socket.
2. If necessary, remove the condensation drain hose and any
residual fluid from it.
3. Clean the device according to the Maintenance chapter.
4. Store the device according to the Storage chapter.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection (230 V/1~/50 Hz).
•
Check the power cable for damages.
•
Check the on-site fusing.
•
Have the electrics checked by a specialist company for
cooling and air-conditioning or by Trotec.
The device is running, but there is no formation of
condensate:
•
Check whether the condensation drain hose is positioned
correctly.
•
Check the room temperature. Observe the device's
permissible operating range according to the technical
data (see chapter
Important information regarding the
dehumidification performance and drying rate
•
Ensure that the relative humidity complies with the
technical data (see chapter
regarding the dehumidification performance and drying
rate
).
•
Check the preselected humidity level at the hygrostat's
control dial (8). The humidity in the room must be above
the selected range. Reduce the desired humidity level by
turning the control dial (8) to the right (towards the word
DRIER
).
•
Check the condensate pump for proper functioning or
unusual vibrations and sounds. Remove external dirt (see
chapter Maintenance).
•
Check the air filter for dirt. If necessary, clean or replace
the air filter (see chapter Maintenance).
The device is loud or vibrates:
•
Check whether the device is mounted horizontally.
•
Check whether the air filter has been inserted correctly.
An alarm signal is emitted:
•
The pump attempts to pump off a larger quantity of water.
The device will be switched off completely. As soon as the
water is gone, the device will restart and the alarm dies.
•
If the emitted alarm signal is a continuous tone, the
condensate pump inside the device needs to be checked.
To do so, please proceed as follows:
1. Hold onto the mains plug while pulling the power cable out
of the mains socket.
2. Open the screw connection at the housing.
DH 30 VPR+
DH 60 VPR+
