EN
6
Operating manual – dehumidifier / climate manager DH 30 VPR+ / DH 60 VPR+
Transport, assembly and preparation for start-up
Always utilize the help of another person to transport and
assemble the DH 30 VPR+. Always utilize the help of two other
persons to transport and assemble the DH 60 VPR+. Do not try
to assemble the device without the help of another person. To
lift the device, use a forklift or an elevating truck as appropriate.
Observe the following instructions:
•
When assembling the device, keep a sufficient distance to
heat sources.
•
When assembling the device, especially in wet areas,
secure the device locally with an RCD (Residual Current
protective Device) which complies with the relevant
regulations.
•
Make sure that extension cables are completely unrolled.
•
Insert the mains plug into a properly secured mains
socket.
•
When assembling the device, observe the minimum
distance from adjacent walls or other objects as described
in the Technical Data chapter.
C
C
A
B
D
Assembly
Assemble the device as follows:
Select screw and dowel sizes suitable for the weight of the
device (see technical data) and the structure of the wall.
Warning
A falling device can cause injuries!
Always transport
and assemble the device with the help of other
persons.
Never stand below the device when it is
suspended. Ensure adequate stability of the device's
wall fixing.
1. The table or floor on which you should now unpack the
device must be clean.
2. Open the screw connection at the housing.
DH 30 VPR+
DH 60 VPR+
Info
The principle of hanging up the DH 60 VPR+ is the
same as for the DH 30 VPR+. But the DH 60 VPR+
comes with a longer suspension rail.
The following steps will be illustrated by using the
DH 30 VPR+ as example.
