Trojan DUAL 510, Инструкция и руководство по сборке

Страница: 7 / 26

1064M-7
4. ASSEMBLY STEPS
Unpacking the unit
1. Using a razor knife (Box Cutter) cut the outside bottom edge of the box along the dotted Line. Lift Box over the
unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged parts are found, or
parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into steps. Remove the tools first, then remove the hard-
ware for each step as needed to avoid confusion.
Step 1: Consol Mast assembly
1. Locate the Consol Mast (10) and Consol Mast Cover (41) and slide the Cover onto the Mast as far as it will go.
Make sure the Consol Mast Cover (41) is facing the correct way.
2. At the top opening of the Main Frame (1), there is a Computer Cable (32) tied with a guide wire. Unravel the wire
and feed the Computer Cable (32) it into the bottom of the Consol Mast (10) with the other side coming out of
the top opening.
3. Install the Consol Mast (10) into the receiving bracket on the top of the Main Frame (1). Pull on the Computer
Cable, lightly, at the top of the mast while installing. This will ensure the cable does not get pinched or shorted
during mast assembly.
4. Attach one 3/8” x 2T Split Washer (120) and one 3/8” x 23 x 2T Curved Washer (114) onto one of the 3/8” x 3”
Hex Head Screw (119) and install this into the front of the Consol Mast. Attach two 3/8” x 19 x 1.5T Flat Washers
(94) and two 3/8” x 2T Split Washers (120) onto two 3/8” x 3” Hex Head Screws (119) and install them into the
left side of the receiving bracket of the Consol Mast (10).
NOTE: The Computer Cable runs through the Consol Mast (10). Be careful not to damage or pinch this cable
during this procedure as damage to the Consol Assembly could result.
5. Use the 13/14mm Wrench (111) to tighten the three
screws firmly. These bolts should be tightened as much
as possible. Snap the consol mast cover into place.
6. There are three connectors at the top opening of the
Consol Mast (10), two Hand Pulse Wires (37) and one
Computer Cable (32). Connect these to the mating
connectors on the back of the Consol Assembly (31).
7. Store the excess wiring by pushing it back into the
Consol Mast (10) as you carefully install the Consol
Assembly (31) onto the mounting plate of Consol
Mast (10). Secure the consol with four M5 x 10mm
Phillips Head Screws (78), using the Combination M5
Allen Wrench & Phillips Head Screw Driver (108).