1064M-9
STEP 03
STEP 3: Connecting Arm & Rear Rail assembly
1. Align the hole in the Rod End bearings, at the end of the Connecting Arms (7,8) with the hole in the bracket of the
Lower Handle Bars (4,5). There is a sleeve spacer already installed in the Rod End and held in place with a twist tie.
Make sure these spacers do not fall out during assembly. The Rod End bearing should be positioned to the inside of
the bracket on the Lower Handle Bars. Secure with two 5/16” x 32mm Hex Head Screws (71) through the left and
right Lower Handle Bar brackets and the Rod End. Install two 5/16” x 20 x 1.5T Flat Washers (98), two 5/16” x 7T
Nyloc Nuts (105) and the 5/16” x 32m/m Hex Head Screws (71), tightening firmly using the 12mm Wrench (110)
and 13/14 mm Wrench (111).
2. Attach both Rail Stabilisers (16) to the rear end of the Main Frame (1) and secure with 2 two 3/8” x 2-1/4” Button
Head Socket Screws (76), two 3/8” x 19 x 1.5T Flat Washers (94) and two 3/8” x 7T Nyloc Nuts (89), using 13/14
mm Wrench (111) and the Combination M5 Allen Wrench & Phillips Head Screw Driver (108).
3. Install the Rail Assembly (15) between the rear end of the Rail Stabilisers (16) and secure with four 3/8” x 2-1/4”
Button Head Socket Screws (76) and 3/8” x 23 x 2T Curved Washers (114), using the Combination M5 Allen
Wrench & Phillips Head Screw Driver (108).
Содержание DUAL 510
Страница 23: ...1064M 23 12 EXPLODED DRAWING...