Triumph Daytona Moto2 765 2020, Руководство пользователя

Страница: 43 / 163

General Information
43
Warning
After selecting a riding mode, operate
the motorcycle in an area free from
traffic to gain familiarity with the new
settings.
Do not loan your motorcycle to
anyone as they may change the riding
mode settings from the one you are
familiar
with, causing loss of
motorcycle control and an accident.
Warning
If Traction Control (TC) has been
disabled in the Main Menu as
described on page
51 then all TC
settings that were saved for all riding
modes will be overridden.
TC will remain off regardless of the
riding mode selection, until it has been
re-enabled or the ignition has been
switched off then on again.
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
Note
The riding mode will default to ROAD
when the ignition is switched ON, if the
TRACK or RIDER Mode was active the
last time the ignition was switched OFF
with TC set to TRACK or OFF in the
required mode.
Otherwise, the last selected riding mode
will be remembered and activated when
the ignition is switched ON.
If the mode icons are not shown when
the ignition switch is in the ON position,
make sure that the engine stop switch
is in the RUN position.
o7:29
12.5
1
E
2 3 4 5 6
PM
F
c
mph
8
6
4
2 0
14
RPM
x1000
10
N
12
TO SELECT
m
3
2
2
1
1. Mode button
2. Current riding mode
3. New riding mode
To select a riding mode:
• Press and release the MODE button
on the left hand switch housing to
activate the riding mode selection
tray.
• The currently active riding mode
icon is shown in the right hand side
of the display.