General information
38
Traction Control Settings
Warning
Do not attempt to adjust the traction
control settings while the motorcycle is
in motion as this may lead to loss of
motorcycle control and an accident.
The traction control can be set to one of
the following conditions:
On
Optimal traction control setting for road
use, allows minimal rear wheel slip.
Off
Traction control is turned off. The TC
disabled warning light will be illuminated
(see page
29).
Traction control defaults to on after the
ignition has been switched OFF and
then switched ON again.
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on wet/
slippery road surfaces may cause the
rear wheel to slip, and may result in
loss of motorcycle control and an
accident.
To Disable the Traction Control
To access the traction control setting;
Make sure the motorcycle is stationary
and in neutral.
Turn the ignition to the ON position and
put the engine start/stop switch in the
RUN position.
Press and release the SCROLL button
on the left hand handlebar switch
housing until ’ttcOn’ is shown in the
display.
Press and hold the SCROLL button for
more than one second to change
between traction control on and
traction control off.
10
20
30
40
50
60
70 80
90
100
110
120
120
0
0
20
40
60
80
100
120
140
160
1
80
200
1
1.
Traction control off display (Street
Twin shown)
