TRIUMPH BOARD 2000, Руководство пользователя

Страница: 54 / 57

53 53
Replacing the lamp
The projector automatically detects the lamp life. When the lamp life
is nearing the end of use, you will receive a warning message.
Lamp is approaching the end of its useful life
Replacement suggested!
Warning! Lamp
When you see this message, please contact your local reseller or
service center to change the lamp as soon as possible. Make sure
the projector has been cooled down for at least 60 minutes before
changing the lamp.
Lamp Replacement Procedure:
1. Switch off the projector power by pressing the “ ” button.
2. Allow the projector to cool down for at least 60 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the cover.
1
5. Lift up and remove the cover.
2
6. Unscrew the two screws on the lamp module.
3
7. Pull up the lamp handle and remove the lamp module slowly
and carefully.
4
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and use “Lamp Reset” after the lamp
module is
replaced.
1
3
4
2
Replacing the lamp

The screws on the
lamp cover and the
lamp cannot be
removed.

The projector cannot
be turned on if the
lamp cover has not
been placed back on
the projector.

Do not touch the
glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it was
accidentally touched.