Triumph Adler P-3521DN, Руководство по продвинутой эксплуатации

Страница: 72 / 130

2-52 Using the Operation Panel
AppleTalk (AppleTalk setting)
AppleTalk is a communications protocol used primarily on Macintosh
computers and also refers to the Mac OS network functions.
AppleTalk assigns 24-bit network addresses (a 16-bit network section
and an 8-bit node address) that are used to identify devices (computers,
printers, etc.) on the network.
When the power is turned on, a broadcast signal is sent out onto the
network and the addresses and machine names are automatically
assigned. The default setting is
On
.
1
After entering the administrator ID and password, press U or V
repeatedly until
>AppleTalk
appears.
2
Press [OK] . A blinking question mark (
?
) appears.
3
Press U or V to select whether AppleTalk is enabled.
4
Press [OK] .
5
Press [MENU] . The display returns to
Ready
.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
1
After entering the administrator ID and password, press
U
or
V
repeatedly until
>IPSec
appears.
2
Press [OK] . A blinking question mark (
?
) appears.
3
Press U or V to select whether IPSec is enabled.
4
Press [OK] .
5
Press [MENU] . The display returns to
Ready
.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting
is
Auto
.
1
After entering the administrator ID and password, press U or V
repeatedly until
>LAN Interface
appears.
>AppleTalk
? On
Note
IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
>IPSec
? Off
Note LAN Interface is only displayed when the optional network
interface kit (IB-50) is installed.