1
Triton Xerophyte
Controller Installation
27
2
Fig 25
Make sure the fitting of the batteries is done correctly, otherwise the PCB within the Triton
Xerophyte Controller Unit could be damaged.
Replace the battery compartment cover and secure it in place using the two fixing screws
previously removed.
Ensure that the battery compartment cover sits flush with the rear housing of the Triton
Xerophyte Controller Unit and that both retaining screws are tight (Fig 20).
DO NOT overtighten the screws.
Attach the Triton Xerophyte Controller Unit to the fixing bracket.
Fit Triton Xerophyte Controller Unit cut-outs over the bracket fixing lugs (Fig 23) and
slide down into place. Secure with the single screw at the bottom of the Triton
Xerophyte Controller Unit (Fig 24).
DO NOT overtighten the screw.
Always use ALKALINE batteries in your Triton Xerophyte Controller Unit.
3
For Wireless Connectivity Only: Fit 3 x AA sized ALKALINE batteries (not supplied) into
the Triton Xerophyte Controller Unit as shown in Fig 25.
Always use of ALKALINE batteries. Other batteries might cause reconnection
connectivity problems. Flat Batteries must be replaced with new batteries
