Triton Xerophyte
Controller Installation
23
Fixing bracket installation
When installing the Triton Xerophyte Controller Unit, We recommend the Triton Xerophyte
Controller Unit be mounted on the wall at a convenient place inside the enclosure whereby the user
can easily start and stop the shower but also have easy access before entering the shower to
activate the war-up procedure.
With the Triton Xerophyte Mixer Unit located and the data cable routed it is now time to fit
the Triton Xerophyte Controller Unit.
Using the fixing bracket and a spirit level, position the bracket in the desired location,
remembering to consider your cable routing position (Fig 16).
Hold the fixing bracket in position and mark the top and bottom screw fixing holes A (Fig
16). Remove the bracket from the wall then drill and plug the wall for the fixing positions A.
(An appropriate drill bit should be used. If the wall is brick, plasterboard or a soft building
block, appropriate wall plugs and screws should be used).
Secure the mounting bracket to the wall using the appropriate fixings.
For Wired Connectivity Only: Whilst securing the mounting bracket to the wall, the data
cable MUST be pulled through so that approximately 150mm protrudes from the wall see
Fig 15.
150m
If the data cable is being routed through wall cavities, chased into solid walls or surface
mounted, then appropriate trunking/conduit MUST be used. Data cables MUST be fitted in
such a way so that they can later be removed for maintenance or servicing.
Fig 15
Fig 16
A
