Triton t150z, Инструкция по установке и эксплуатации

Страница: 27 / 37

5
t150z pumped thermostatic electric shower
FAULT FINDING
Important: Switch off the electricity at the mains supply and remove the circuit fuse before
attempting any fault finding inside the unit.
Problem/Symptom Cause Action/Cure
Shower inoperable, no
water flow.
Water too hot.
Water too cool or cold.
4 Water will not stop
flowing from unit
unless switched off at
isolating switch.
5 Pressure relief device
has operated (water
ejected from PRD
tube).
. Interrupted power
supply.
.
Unit malfunction.
. Thermal cut-out
operated.
. Temperature control
set incorrectly.
. Unit malfunction.
. Temperature control
set incorrectly.
. Maximum
temperature stop set
incorrectly.
. Unit malfunction.
4. Control ribbon cable
is not connected to
PCB.
5. Blocked
showerhead.
5. Twisted/blocked
flexible shower hose.
5. Showerhead not
removed while
commissioning.
.. Blown fuse or circuit breaker. Check supply
Renew or reset fuse or circuit breaker. If it fails
again, consult a qualified electrician.
..
Power cut? Check other appliances and if
necessary, contact local Electricity Supply Co.
.. Have unit checked. Ring Customer Service.
.. The thermal cut-out safety device has operated.
Have the unit checked by a suitably qualified
service engineer or contact Customer Service.
.. Alter the temperature control.
.. Have the unit checked by a suitably qualified
service engineer or contact Customer Service.
.. Alter the temperature control.
.. Alter the Maximum temperature stop.
.. Have the unit checked by a suitably qualified
service engineer or contact Customer Service.
4.. Remove cover and connect ribbon cable.
5.. Clean sprayplate and then fit a new PRD.
5.. Check for free passage through hose. Replace
hose if necessary and then fit new PRD.
5.. Fit new PRD. Commission unit with showerhead
removed.
FAULT FINDING
Problem/Symptom Cause
Action/Cure