Triton t150z, Инструкция по установке и эксплуатации

Страница: 12 / 37

0
t150z pumped thermostatic electric shower
PLUMBING CONNECTIONS
Plumbing to be carried out before wiring
DO NOT use jointing compounds on any pipe
fittings for the installation.
DO NOT solder fittings near the shower unit
as heat can travel along pipework and damage
components.
Compression fittings
Must be used to connect to
the inlet of the shower.
Note: An additional stopvalve (complying with
Water Regulations) Must be fitted in the water
supply to the shower as an independent means
of isolating the water in order to carry out
maintenance or servicing.
Important: Before completing the connection
of the water supply to the inlet of the shower,
flush out the pipework to remove all swarf
and system debris. This can be achieved by
connecting a hose to the pipework and turning
on the water supply long enough to clear the
debris to waste.
Procedure
Turn off the water supply isolating stopvalve.
Connect the water supply to the Inlet of the
shower via 15mm copper, stainless steel or plastic
pipe using a 15mm x 15mm compression fitting,
see
(fig.0) for advice on Rear Entry fitting.
Note: If installing a feed pipe from the
back, the use of a soldered Elbow connector
is recommended. It should be positioned
approximately 105mm from the inlet
connector centre. The centre of the inlet
valve to the wall surface is 21mm.
Fig.0
105mm
21mm
Centre of
Soldered
Elbow
Centre of
Water Inlet
Wall