Tripp Lite NGI-M08C4-L2, Руководство пользователя

Страница: 22 / 313

22
ATTENTION
The product should be mounted in an Industrial Control Panel and the ambient
temperature should not exceed 75°C.
ATTENTION
A corrosion-free mounting rail is advisable.
When installing, make sure to allow for enough space to properly install the cabling.
Wiring Power Inputs
You can use “Terminal Block (PWR)” for Primary Power input and “Terminal Block (RPS)”
for secondary power source for Redundant Power Input.
To insert power wire and connect the 12~60VDC power to the power terminal block, follow the
steps below:

Step 1 : Insert the positive/negative DC wires into the V+/V- terminal, respectively.

Step 2 : Use your finger to press the green plug on top of terminal block connector to insert
power cables.

Step 3 : Insert the terminal block connector which includes “PWR” and “RPS” into the
terminal block receptor which is located on the top panel.
WARNING

Use copper conductors only, 60/75˚C (140/167°F) , tighten to 0.56 N•m (5
lb•in).

The wire gauge for the terminal block should range between 12~18 AWG .
Redundant Power Input:
You can use “Terminal Block (PWR)” as primary power or “Terminal
Block (PWR)” for redundant power.
Connect power cables to terminal block: Use your finger to press the orange plug on top of
terminal block connector to insert power cables.