Trinity Highway QuadGuard M Wide, Руководство по сборке изделия

Страница: 30 / 64

TrinityHighway.com 29 Revision D March 2021
Step 5
The Mushroom Washer must lay flat against the Fender Panel with its standoff completely
through the Fender Panel slot (Detail B).
Important:
Starting from the Backup, attach and tighten each Bay section one
at a time.
Step 6
Check Diaphragm spacing to ensure 36” [914 mm]
between rear faces of consecutive Diaphragms as
shown in Fender Panel assembly drawing (Figure
29).
Step 7
Once proper spacing has been achieved, tighten
the Mushroom Washer Assembly (small hex) nut
until it reaches the end of the screw threads.
Assemble the remaining Diaphragms and Fender
Panels following the same procedure.
Tighten rail nuts (large hex) at the front of the
Fender Panels. Ensure the rail bolt shoulder is
seated within the Fender Panel slot.
Detail B
Mushroom Washer Orientation
Detail A
Mushroom Washer Attachment
Figure 29
Proper Diaphragm Spacing
5/8 RAIL NUT (LARGE)
6” DIE SPRING
DIAPHRAGM
OR BACKUP
MUSHROOM
WASHER
FENDER PANEL
LONG SLOT IN
FENDER PANEL
FENDER PANEL
MUSHROOM
WASHER
CORRECT INCORRECT
FENDER PANEL
DIAPHRAGM
OR BACKUP
DIAPHRAGM
HINGE PLATE
BAY SPACING
36” [914 mm]
STANDOFF