Revision C August 2014
www.trinityhighway.com
30
All rights in copyright reserved
Attach the flat washers so they are flush with the outside humps of the Fender Panels (see
Figure 45).
13) Checking the System Assembly
At this point recheck to ensure that all fasteners are properly tightened throughout the
system (anchor bolts, etc.) (see Table A). Check all Fender Panels. If they do not fit tightly
against the underlying panel, system realignment may be necessary. See Figure 30 for
narrow systems and Figure 33 for wide systems.
Warning:
Anchor Studs
Torqued to 165 N-m [120 ft-lb]
May slightly protrude above
nuts (see Figure 14 on p. 16).
All Other Bolts Tightened
Fender Panel
Maximum gap allowed:
Narrow – 20 mm [0.78”]
Wide – 25 mm [1.00”]
14) Cartridge Attachment
To complete the assembly of a QuadGuard
®
CEN, place a Type E Cartridge in each Bay
except the first Bay and second Bay for 5, 6, & 8 Bay systems (see Figures 46 through 48).
Figure 45
