Revision C August 2014
www.trinityhighway.com
26
All rights in copyright reserved
Check diaphragm spacing to ensure 915 mm [36”] between rear face of consecutive
Diaphragms (see Figures 36 and 37).
Once the proper spacing has been achieved, tighten the nut to compress the spring. The spring
must be compressed a minimum of 1 mm and a maximum where the nut reaches the end of the
bolt threads.
Attach the remaining Diaphragms and Fender Panels following the same procedure.
Figure 36
Proper spacing between Bays
(Narrow System shown)
Figure 35
Fender Panel Assembly for Wide Systems
5/8” X 8-1/2”, G8
FLATHEAD SOCKET SCREW
FENDER PANEL
5/8” X 4” HEX BOLT
5/8” LOCK WASHER
5/8” HEX NUT (SMALL)
LAST DIAPHRAGM
5/8” HEX NUT (SMALL)
1-1/2” DIE SPRING
BACKUP
MUSHROOM WASHER
