Trillium ROTO-JET VSR 175, Руководство по разборке и сборке

Страница: 38 / 53

VSR 175 35
3.7.2.1. Insert the two driveshaft alignment pins (P/N 0661975) into the shaft.
3.7.2.2. Place the rotor (3) onto the drive shaft (5). Clean the eight socket head cap
screws (83) and counter bores in the rotor for these cap screws. Install the eight
socket head cap screws (83), evenly thread the screws until the rotor (3) is
seated on the drive shaft (5), and then torque to 100 ft. lbs.
3.7.2.3. Lubricate and install cover O-ring (579) into the groove on the cover (578).
3.7.2.4. Install the mounting bolt cover (578) into the bore of the rotor (3), being careful to
not damage the O-ring (579).
3.7.2.5. Lubricate and install the cap screw O-ring (580) onto the cap screw (581). Insert
the cap screw (581) into the center hole of the cover (578). Torque to 36 ft. lbs.
3.8 ROTOR COVER AND PICK-UP TUBE ASSEMBLY
3.8.1. Lubricate and install rotor O-ring (6) on the lip of the rotor (3). Place pick-up tube (1) in
the rotor. Lubricate the O-ring bore in the rotor cover (4) which engages the rotor O-ring
(6).
3.8.2. Thread two rotor alignment pins (P/N 0665014) into the rotor (3). Using three 7/16”
eyebolts (P/N 0665199) threaded into the rotor cover for lifting, place the rotor cover (4)
on the rotor (3). Guide the round extension tube portion of the pick-up tube through the
center hole in the rotor cover (4) as you lower the rotor cover (4) onto the rotor (3). Be
sure all holes in the periphery of the rotor cover (4) line up with the holes in the rotor (3),
as the hole pattern is not symmetrical.
3.8.3. Install the twenty socket head capscrews (7) into their original rotor cover (4) capscrew
holes and tighten evenly to draw the rotor cover (4) down. Torque the capscrews to 68
ft. lbs.
3.9 ENDBELL ASSEMBLY
3.9.1. Install the two endbell alignment rods (P/N 060580573) in the nine o’clock and three
o’clock positions where the endbell mounting cap screws (63) would normally be.
3.9.2. Thread two eyebolts (P/N 066572) into two evenly spaced manifold mounting holes
(32). Using the eyebolts to lift the endbell (26) over the cover (4) and down onto the
motor endplate (15). Be sure that all of the holes in the periphery of the endbell (26) line
up with the holes in the endplate (15), as the hole pattern is not symmetrical.
3.9.3. Install the twelve socket head cap screws (63), and tighten evenly to draw the endbell
(26) down onto the endplate (15). Torque the cap screws to 54 ft. lbs.
Note: If the drive shaft, rotor, or rotor cover were replaced, the seal height must be
checked per section 2.8.