Page 7
Miniguard IID
(A) Programming after Set-up:
In order to program the unit, it must be in the Program
Mode. If you came from SETUP and didn’t exit or reset,
go on to (B), "Adding Telephone Numbers”. Otherwise:
1. Press red button for dial tone and enter "
✽
"
2. Enter the Program Code (5269 if unit is new).
You will hear two beeps. The unit is now ready to
program.
(B) Adding Telephone Numbers:
1. Unit must be in Program Mode (see section A).
2. Enter Resident Code that you wish to file the
telephone number under.
(The number will be 2, 3,
or 4 digits.)
You will hear one beep when you have entered the
correct number of digits.
3. Enter the telephone number.
(The telephone
number can be up to twelve digits in length.)
4. Press "#" to complete the entry.
You will hear two beeps.
Repeat the above steps until you are finished.
To continue programming, enter the desired function
code.
- or -
5. Enter "# #" to exit Program Mode, otherwise,
continue programming by entering the desired
function code.
(C) Deleting Telephone Numbers:
1. Unit must be in Program Mode (see section A).
2. Enter the Resident Code you wish to delete.
You will hear one beep.
3. Enter "#" .
Two beeps indicate Erasure complete.
Repeat steps 2 and 3 until you are finished.
To continue programming, enter the desired function
code.
- or -
4. Enter "# #" to exit Program Mode, otherwise,
continue programming by entering the desired
function code.
Note: If you wish to change a telephone number under
an existing Resident Code, use the instructions for
Adding Telephone Numbers and enter the new number
in place of the old one.
(D) Programming Entry Codes:
Entry Codes make it possible for the resident to enter a
Code (P.I.N. number) at the unit and gain access without
placing a call.
1. Unit must be in Program Mode (see section A).
2. Enter "# 1".
3. Enter any 4-digit number between 0000 and
8999.
You will hear two beeps, indicating the number has been
recorded in the Miniguard IID’s memory.
Repeat steps 2 and 3 until you are finished.
Note: Three beeps indicate the code already existed.
Note: Codes beginning with “9” will activate relay #2.
To continue programming, enter the desired function
code.
-or-
4. Enter "# #" to exit Program Mode, otherwise,
continue programming by entering the desired
function code.
(E) Changing the Program Code:
This feature allows you to change the Program Code to
something other than the factory preset of 5269.
1. Unit must be in Program Mode (see section A).
2. Enter "# 7"
You will hear two beeps.
3. Enter 4 digits for new Program Code.
-or-
4. Enter "# #" to exit Program Mode, otherwise,
continue programming by entering the desired
function code.
Note: The 5269 Code (or any other previous code) is
now invalid, so keep a good, safe record of your new
Program Code for future use.
Note: If you lose the ability to access the Program Mode
after performing this step, call TRIGON service. We
have the ability to remotely reset the Program Code back
to 5269.
(F) Deleting Entry Codes:
1. Unit must be in Program Mode (see section A).
2. Enter "# 2"
3. Enter the Entry Code that you want to delete.
You will hear two beeps. Erasure complete.
Three beeps indicate no Code match found.
To continue programming, enter the desired function
code.
- or -
3. Enter "# #" to exit Program Mode, otherwise,
continue programming by entering the desired
function code.
PROGRAMMING
PROGRAMMING
PROGRAMMING
PROGRAMMING
PROGRAMMING
Содержание MiniGuard IID
Страница 17: ...Page 17 Miniguard IID ...
