Trigon Electronics MiniGuard IID, Инструкции по установке и программированию

Страница: 12 / 17

Page 12
Miniguard IID
OPERATION OPERATION OPERATION OPERATION OPERATION
Direct Entry Codes:
1. Press the start button for dialtone.
2. Enter " # " and your four digit Entry Code
(PIN Number).
Site Identification:
The Site I.D. number must be programmed into the unit
before the feature can be used. See “Programming Site
Identification Number”
1. Enter #.
This instructs the unit to transmit the four digits (tones)
of its site I.D. code. The tones may be decoded by using
a TRIGON DECODER.
Figure 5
Figure 4
1 2
ABC
3
DEF
4
GHI
5
JKL
6
MNO
7
PRS
8
TUV
9
WXY
*
0
#
Open Door / Gate and
disconnect from call
Activate Secondary device (camera etc.)
and disconnect from call
Activate Secondary device (camera etc.)
and continue conversation
Hang up from gate call
Calls from the gate
1
2
ABC
3
DEF
4
GHI
5
JKL
6
MNO
7
PRS
8
TUV
9
WXY
*
0
#
Latching Keys
Latch Door / Gate open
Unlatch Door / Gate
Latch secondary
device (camera etc.)
Unlatch secondary
device (camera etc.)
Hang up call
Calling a Tenant:
1. Press the red start button and use the keypad
buttons to scroll the electronic directory.
2. Press the red button to aquire dialtone.
3. Enter the Resident Code located next to the
tenant’s name on the LCD directory.
You will hear tenant answer.
Granting Visitor Entry:
Answer telephone and identify visitor. You may choose
from the following options: (fig.4)
1. Enter "0" to activate Relay 1 and disconnect.
2. Enter "8" to activate Relay 2 and disconnect.
3. Enter "9"to activate Relay 2 and continue
conversation.
Note: On rotary telephones “5” or higher can be used
to activate Relay 1.
Denying Visitor Entry (disconnect):
To deny entry
4. Enter "7" to force disconnect. Hang up
telephone.
Note: It is important that the tenants recognize the
responsibility to hang up the Trigon unit by pressing
the appropriate key on their telephone's keypad.
Otherwise, the visitor may walk away leaving the unit
active. Shortly, the loud off-hook indicator tone from
the telephone company will be heard for the remaining
duration of the call length.
Latching/Unlatching Relays:
This feature must be enabled in the initial SETUP of
the units programming. Refer to the SETUP section in
this manual. To latch (hold close) a relay, place a
telephone call to the Miniguard IID. The Miniguard
IID will auto-answer and you will hear a brief tone in
the speaker. Refer to Fig. 5 for options:
1. Enter “3” to latch relay 1
2. Enter “4” to unlatch relay 1
3. Enter “5” to latch relay 2
4. Enter “6” to unlatch relay 2
5. Press “7” to hang unit up.