Trigon Electronics MiniGuard IID, Инструкции по установке и программированию

Страница: 10 / 17

Page 10
Miniguard IID
Editing the Electronic Display Editing the Electronic Display
Editing the Electronic Display Editing the Electronic Display
Editing the Electronic Display
(O) Editing the Miniguard IID from the units keypad.
For remote editing, see Remote Editing of Display on
page 11.
All telephone numbers and entrance codes must be
completed per programming instructions prior to editing
of the display (see pg. 6) .
1.Unit must be in Program Mode(see section A),
2. Press "# 92".
The Display is divided into two lines. The top line will
have a series of periods for each letter position.The
bottom line will show the first resident code in the unit's
memory.
You may replace each period with a desired letter, space,
or leave the period as in “SMITH J.”.
3. Enter each letter, space, or period with two (2)
key strokes on the keypad.
- Example -
To Enter: S M I T H J.
The letter "S" on the telephone keypad is on the 7 key
in the third position. To place the letter "S" in the
electronic display enter "7 3".
An "S" will now appear and the cursor will move right
to the next position.
Enter "6-1" (key #6-FIRST position) for letter"M".
Enter "4-3" (key #4-THIRD position) for letter"I".
Enter "8-1" (key #8-FIRST position) for letter"T".
Enter "4-2" (key #4-SECOND position) for letter"H".
Enter "1-1"(key #1-FIRST position) for, "space"
Enter "5-1"(key #5-FIRST position) for letter"J".
The symbol ‘.’ is displayed, so use a single "0" to skip
the '.' and move to the next charcter location.
Use ‘11’, ‘11’, ‘11’, etc. to replace the remainder of the
periods on that line with SPACES.
4. Press "#" to continue with the next listing.
Character Table
A 21 N 62 Space 11
B 22 O 63 & 98
C 23 P 71
D 31 Q 12
E 32 R 72
F 33 S 73
G 41 T 81
H 42 U 82
I 43 V 83
J 51 W 91
K 52 X 92
L 53 Y 93
M 61 Z 13
- Example -
" Smith R." equals 73,61,43,81,42,11,72
Notes:
When a SPACE is desired, press " 11".
When '&' is desired, press "98".
For Q enter '12'. For Z, enter '13'.
To
TAB RIGHT
or "skip" use key "0".
Key " * " is for BACK-UP.
Key"#" is
GO FORWARD
to next complete listing.
Cursor is automatically put in the 1st position on
moving to another listing.
To get the
PERIOD
in 'SMITH J.' tab right using ‘0’
this will leave the existing period in place after the
letter ‘J’.
From the Miniguard IID unit's keypad, only “A”
through “ Z “, SPACE, '&',and pre-existing
PERIODS are possible.
Use keypad sequence “11” to erase a position.
Use keypad sequence # * to restore Cursor to the
first position of any given listing.
To delete a listing, remove the Resident Code in
normal Program Mode fashion.
5. Press the start button to exit the Edit Program .
Note: Alphabetizing is automatic, based on the first letter
of each listing.